Receivers: Auto, Manual, OFF. How to setup the appropriate mode?

Depending on what model your current Receiver is, you might recognise up to three modes that will be common for most of them:

1. Auto – Allows the receiver to work by Thermostat commands, which means that only in this particular mode is the device allowed to communicate with Thermostat. 
   
   
   
   NOTE: AUTO always sets up the device to work with the thermostat, despite the fact that the design of the receiver might vary. See photo below for reference: 
   
   
   
   
2. Manual – Overrides Thermostat settings, turns the heating on, until it is turned off manually.
   
   
   
   
   
3. OFF (Depending on the receiver’s model) – Turns off the heating manually.
   
   
   
   

You may find other relevant articles, videos and guidelines at: 
https://salus-controls.zendesk.com/hc/en-us

If you still experience any issues and you couldn't find a solution on our self-help centre please contact us at: techsupport@salus-tech.com